Do you know what is load testing?

Do you know what is load testing?

There are multiple factors that can condition the safety of a load and the integrity of its protective packaging. Performing load testing implies taking into account how these hazards may affect the packaging+product system, to then plan safer systems.  Here we tell...

read more
EN 12195: load securing on road vehicles

EN 12195: load securing on road vehicles

The EN 12195 standard was established to address the problems resulting from an inadequate load stowage in road vehicles. Unsafe stowage in road vehicles has led to a significant number of accidents and economic losses. Indeed, it is estimated that 25% of road freight...

read more
3 axis accelerometer vs 6 axis gyro: what is the difference?

3 axis accelerometer vs 6 axis gyro: what is the difference?

3 axis accelerometer vs 6 axis gyro is a choice that you might face when considering which of these technologies is the most suitable to add to a device. Learn about both sensors, which types of measurements they can support and where to use them.   What is a...

read more
Vertical Vibration Table + Pitch & Roll Module vs Hexapod

Vertical Vibration Table + Pitch & Roll Module vs Hexapod

Etymologically, Hexapod comes from the Greek words “Hexa” (six) and “podos” (feet). It refers to a platform that has six feet... well, six linear actuators. This is a complex system that allows for movements along the 3 Cartesian axes: movements along the vertical,...

read more
ISTA vs. ASTM: which one suits your products best?

ISTA vs. ASTM: which one suits your products best?

Many companies looking to guarantee the integrity of their goods during transportation and to optimize their packaging hesitate when it comes to choosing which procedure to use between ISTA vs ASTM to perform their performance tests.  Both the ASTM standards and the...

read more
ISO 11607: everything about it

ISO 11607: everything about it

Sterilized medical device packaging must guarantee that the contents within will remain sterile throughout the entire lifecycle of the product – from the moment it leaves the factory until the final consumer opens it to use it. The ISO 11607 standard addresses this...

read more
Prevent unit load deformation with the new InnVision

Prevent unit load deformation with the new InnVision

Before going on the road, it is paramount to know how the transport and its hazards will affect the load, with the purpose of optimizing it in order to improve its stability and safety, thereby avoiding shrinkage and accidents. Preventing unit load deformation is one...

read more